INSTALLATION GUIDE
KALE FANS
www.kalefans.net
INSTALLATION GUIDE
EURUS
-12-
-11-
6. Start Installation
1
Data Confirm for Installation Site
2
Check Before Installation
Check all accessories. Prepare safety equipment(safety belt, safety cap etc), life truck and installation tools.
3
Install Mounting Brackets
First confirm the mounting position, keeping the beam is in the mddile of the top plate, and top plate is vertical; spacer and
beam clip must fit together the beam. Use 24# open end wrench(g), speed wrench(f) and 24# socket wrench(o) to tighten
M16x55mm fasteners.
Other mounting brackets also required to install firmly.
4
Cable Through Extension Tube
put cable through the extension tube, leave 30cm outside to connect cables from motor.
keep no scratch on the cable.
5
Install Extension Tube
Put extension tube between the bending pieces, align to the holes with M16X120mm fasteners and pretighten them.
Adjust the tube vertical with level-meter(e), then tighten fasteners with 24# open end wrench(g), speed wrench(f) and
24# socket wrench(o).
For some sites, one more extension tubes will be used, the method to connect two extension tubes as below:
spacer
beam clip
M16x55mm fastener
safety cap
flat washer,
work gloves
diastimeter
lift truck
Confirm installation position
Measure the height to mount fan with diastimeter(t)
Confirm any obstacle or not
Confirm the position on beam to connect steel guy wire
Confirm the position to mount control box
spring washer
steel structure
M16x120mm fastener
M16x120mm fasteners
flat washer
level-meter
flat washer
spring washer
connecting pieces
for extension tubes
cable
extension tube
leave 30cm outside
to vertical, then tighten the fasteners
tubes after connected.
then through extension tube
flat washer
flat washer
spring washer
4
10
9
23
3
15
16
16