21
4
If connecting the drain line to a garbage disposal, make sure that the drain plug has been removed. Your dishwasher
will not drain if the plug is left in place.
Step 15: Performing a pre-test check
Review this list after installing your dishwasher to avoid problems or charges for a service call not covered by your
warranty.
• Make sure that power is turned OFF.
• Open the door and remove all foam and paper packaging.
• Locate the
User Guide
in the literature package.
• Read the
User Guide
for operating instructions.
• Check the door opening and closing. If the door does not open and close freely, or tends to fall, check the spring
adjustments. See Step 1: Check the door balance on page 10.
• Make sure that the wiring is secure under the dishwasher and not pinched or in contact with door springs or other
components. See Step 9: Position the dishwasher under the countertop on page 16.
• Check the door alignment with the tub. If the door hits the tub, level the dishwasher. See Step 10: Level the dishwasher
• Pull the lower rack out about half way. Make sure that it does not roll back or forward on the door. If the rack moves,
adjust the leveling legs. See Step 10: Level the dishwasher on page 16.
• Check the door alignment with the cabinet. If the door hits the cabinet, reposition or relevel the dishwasher. See Step
10: Level the dishwasher on page 16.
• Make sure that water supply and drain lines are not kinked or in contact with other components. Any contact with the
motor or dishwasher frame could cause a noise. See Step 8: Slide the dishwasher partially into the cabinet on page 15.
• Turn on the sink hot water faucet and verify the water temperature. Incoming water temperature must be between
120°F and 150°F. A minimum of 120°F temperature is required for best wash performance. See Preparing the hot water
line on page 9.
• Add a half gallon (2 l) of water to the bottom of the dishwasher to lubricate the pump seal.
• Turn on the water supply. Check for leaks. Tighten connections if needed.
• Remove any protective film (if present) from the control panel and door.
You’ll need:
Remove
the plug
Phillips screwdriver
Screw-type
hose clamps
Coupler for
extending drain line
(if applicable)
