Kalamazoo K-CKTPD-3-NA-NG, Инструкция по использованию и уходу

Страница: 15 / 18

+1.800.868.1699 27 KalamazooGourmet.com 26
Ignition System Batteries
The ignition system for the cooktop burners utilizes a AA battery to power an electronic spark
ignition system. Screw off the ignition module cap to replace the AA battery.
(Figure 17:A)
The ignition module is located behind the control panel, and is accessible from underneath.
Flame Characteristics
Every burner is tested and adjusted at the factory for proper performance. If a burner is
not operating properly, it may be due to variations in the local gas supply or because of
an obstructed orifice. Flames should be stable without lifting from the burner. The flames
should burn cleanly without creating any sooty residue.
A
B
Cooktop Burner Flame Characteristics:
The flame should be blue and stable with only a small
amount of orange, if any, at the tips. There should be little
noise and no lifting.
On HIGH, the inner cone (see Figure 18:A) should be
approximately ½ inch (12.7 mm) long.
On HIGH, the outer cone (see Figure 18:B) should be
approximately 1 inch (25.4 mm) long.
Wok Burner Flame Characteristics:
The flame should be blue and stable with only a small
amount of orange, if any, at the tips. There should be little
noise and no lifting.
On HIGH, the inner cone (see Figure 19:A) should be
approximately 3/4 inch (19 mm) long.
On HIGH, the outer cone (see Figure 19:B) should be
approximately 1 ¼ inches (31.75 mm) high.
To Adjust Burner LOW Settings (All Burners):
The low setting on the main burners can be adjusted
WITHOUT removing the control panel. A long and thin
flat-blade screw driver is needed to make the adjustments.
Light the burner and set it to LOW.
Remove the control knob and insert the screw driver into
the opening in the center of the valve stem (Figure 20:A).
Turn the adjustment screw (see Figure 20:A) until the
flame on the burner is the minimum stable flame height.
The flame should be steady at all ports around the burner.
The flame should not be easily blown out without quickly
reestablishing itself.
A
B
Manual Lighting Procedure:
1. Remove the cover from the cooktop burners.
2. Make sure all control knobs are in the OFF position (see Figure 15).
3. Turn the main gas supply on.
4. Keeping your face well away from the unit, hold a match or lighter wand at the side of the COOKTOP
BURNER. Press in the COOKTOP BURNER control knob (see Figure 14), and turn it to the HIGH position
(see Figure 16). Ignition should take place within 4 to 5 seconds. If the burner does not light within 4
to 5 seconds, turn the knob to the OFF position and wait 5 minutes for the gas to dissipate before
trying again.
5. Once the burner is lit, continue pressing in the control knob for at least 10 seconds until the thermocouple
has detected the heat of the flame.
A
FIGURE 17
FIGURE 19
FIGURE 18
FIGURE 20
A