Operation Manual MUB-1
Model MUB-1
— 4 —
2. Put the Sharp Angle Plate onto the short
shaft on the handle as shown in Figure 8.
Figure 8
3. Use a short section of stock approximately
2-3/4" to 3" in length. Clamp your stock in the
vise so that the edge of the material is even
with the edge of the circle.
4. Make a complete clockwise bend.
5. Leaving the handle in the left most position,
move the material so that the first loop is on
the angled side of the vise's jaw and the edge
of the stock is even with the edge of the circle
as shown in Figure 9.
Figure 9
6. Make a complete counterclockwise bend
Using the Gauge:
1. The gauge (#23) is used when you need
more than one piece bent at precisely the
same length.
2. Simply insert the gauge into the side of
the bender so that the end of it is the exact
distance away from the bender for the length
of stock you need. Tighten the gauge clamp
(#24) as shown in Figure 10.
Figure 10
3. Use the gauge and the stop pin when you
need to make squares. It will enhance your
final results immensely as shown in
Figure 11.
Figure 11