Kaiser+Kraft G246628, Руководство по эксплуатации

Страница: 63 / 182

high-lift pallet truck
6
Subject to change without notice
truck does not lower
the load
The adjusting bolt or adjusting nut not
adjusted properly.
Adjust it properly
Raised load is
lowered of its own.
Leakage in the hydraulic system Seal!
Lowering valve does not close any more
or the valve unit is not sealed because of
dirt
Clean or replace
Incorrect valve set-up. Adjust lowering
valve
Pressure relief valve (pump) is leaky
(pump turns slowly backwards.)
Clean or replace the
valve
Oil loss on hydraulic
cylinder
Sealing elements are worn Replace sealing
elements
The raised load is
lowered too slowly
Temperature too low – the hydraulic
system oil is too thick
Find a warmer
location
Fork does not raise
till upper position
Insufficient oil in the tank Refill with oil (while
the fork is lowered)
Battery discharged Charge the battery
Limit switch is not positioned Reposition the limit
switch
Battery capacity to
low
Battery is not charged enough Recharge
Battery is defective Replace the battery
Battery can not be
charged
Fuse is defective Replace
Battery resp. charger defective Replace battery resp.
charger
Too early battery
discharge
Silted battery Replace battery
Sulphating or other failure in the battery. Replace battery
Accidental earth contact in the electric
system or battery.
Repair or replace
battery
XI. Disposal:
After placing out of service, the high-lift pallet truck parts must be disposed of or
recycled in accordance with legal provisions.