6.2 Reporting transport damage
1. Check the machine for visible and hidden transport damage.
2. Inform the carrier and the manufacturer in writing of any damage without delay.
6.3 Anchoring the machine
The machine may be anchored to the floor.
The following anchoring elements are shipped with the machine:
Foundation bolts for machines without sound enclosure.
Foundation bolts and angle brackets for machines with sound enclosure.
➤ Use the anchoring elements to anchor the machine without stress.
Further information Details of the fixing holes are contained in the dimensional drawing in chapter 13.2.
6.4 Do not remove or change the adjusting screw of the pivoted motor
base
The hex-head bolt that presses against the pivoted motor base from the side serves as an adjust‐
ing screw for the fine adjustment of the belt alignment. A gap between the hex-head bolt and the
pivoted motor base ensures the clearance in radial direction and forms the stop in axial direction.
Fig. 24 Pivoted motor base
1
Adjusting screw
2
Hex nut
➤ Do not remove or change the adjusting screw
1
and corresponding hex-nut
2
.
➤ Contact an authorized KAESER service representative with any questions regarding the align‐
ment of the belt drive.
6
Installation
6.2
Reporting transport damage
40
Installation and Operating Manual Rotary lobe blower
HBPI pr
Number: 9_9572 28 USE
