Kadey-Krogen Yachts 5814, Руководство пользователя

Страница: 74 / 449

©2008 Kadey-Krogen Yachts, Inc.
www.kadeykrogen.com
Subject to change without notice.
Krogen 58’ Manual, Hull 58014 Cablemaster System
55
Cablemaster System
Your Krogen 58’ is equipped with two 24V DC Cablemaster System, Models CM-7,
from Glendinning for easy and convenient pay out and retrieval of your 50 amp, 6/3 (1”
diameter) shore power cords. Each system consists of 75 feet of 1” diameter power cord,
a power unit, hawse pipe, power cord storage area and associated wiring and connectors.
Each power unit is comprised of a drive motor, reduction gearing, guide roller assembly
and relay assembly. There is one Radio Control Receiver which serves both systems.
The power cord storage area for both power cords is located in the Lazarette, Starboard
side. Access to the power cord storage area is through the Lazarette hatch.
Within the hawse pipe, a neoprene gasket/wiper prevents water from entering the power
cord storage area and helps clean the power cords as they are retracted into the vessel.
As part of the delivery packet from Kadey-Krogen, you received a “Glendinning
Cablemaster, Guide to Description, Installation and Operation” manual which provides
excellent comprehensive and detailed information on the operation of your Cablemaster
Systems. We highly recommend you become familiar with the organization, content, and
format of that manual. This owner’s manual will highlight the more important items in
the “Glendinning Cablemaster, Guide to Description, Installation and Operation” manual.
Operation
To operate the Cablemaster systems, turn ‘ ON ’ the circuit breakers labeled ‘ #1 CABLE
MASTER ’ (operates the ‘inboard’ unit) and ‘ #2 CABLE MASTER ’ (operates the
‘outboard’ unit) located on the 24V DC Main Panel Disconnect in the Pilothouse.
To pay out a power cord , you should do the following:
1. Open the hawse pipe cap and lock it in the upright position.
2. Flip toggle switch UP (located immediately above and to the right of the hawse
pipe cap) and grasp the power cord as it extends.
3. Turn the toggle switch back to the neutral (center) position when desired cord
length has extended.
To retrieve a power cord , you should do the following:
1. Grasp the power cord and flip DOWN the toggle switch.
2. Hold the power cord lightly in your hand as it retracts into the hawse pipe.
3. Turn the toggle switch to the neutral (center) position when the desired cord
length has retracted. If retrieving the entire power cord, the Cablemaster will
automatically shut off when the end of the power cord retracts into the hawse
pipe.
4. Unlock the hawse pipe cap from its upright position and secure it over the hawse
pipe opening.