Kabola Ecoline series, Руководство пользователя

Страница: 15 / 32

Instruction manual Kabola KB-Series version 6, 2018
15
(light flashes) (the light will burn continuous)
Figure 8
4.1.6 Mounting the oil filter and oil burner.
The KB-series will be standard supplied with a self-bleeding oil filter, what is SI approved, this oil filter
should
always be hung above the burner , if this filter is not above the level from the oil pump it will not
work correctly!
The oil burner is already mounted on the boiler, the flexible oil hoses, what are fitted on the burner,
needs to be connected to the oil filter, those two flexible oil tubes, an inlet, and a return line. Place
these lines on the filter. On the filter are arrows!
Use the oil line from the fuel oil pipe stainless steel with an inner diameter of 6-8 mm.
For further instructions from the oil burner, refer to the instructions of the burner.
4.2 Starting your system
After the room thermostat is connected, the following steps:
1. Insert the plug into the grounded socket for 230 volt version.
2. Switch the boiler on, at the on / off switch on the control panel. The lamp in the switch indicate
that the system is on.
3. Set the room thermostat. (see manual of the room thermostat)
4. Open the valve on the fuel tank;
5. Open the valve on the oil filter;
6. Disconnect the power from the motor to the oil burner (only Kabola engineer)
7. Use the startup cable, and connect with this cable the power to the motor from the oil pump
8. Assemble the pump pressure gauge at plug P from the oil pump
9. Check if the system is bleeded and check the right oil pressure
10. Start the burner;
11. After ± 2 minutes, the burner will start
12. Check all oil connections for leaks;
13. If the burner does not start, the fault light is on;
14. Wait about 3 minutes;
15. Reset the burner and go to 5.4 (repeat if necessary).
Attention:
The oil burner is tested by the manufacturer, not adjusted. The adjustment of
the
burner has to be done by an experienced installer, because this
requires expert knowledge. To be eligible for warranty, the boiler has to be
adjusted by an approved installer. Contact your Kabola supplier to make an
appointment.
Never adjust the burner using your own initiative!!