MANUAL LEVER PUMP
INSTRUCTIONS AND PRECAUTIONS
PLEASE SAVE THESE INSTRUCTIONS.
READ ALL PRECAUTIONS AND INSTRUCTIONS CAREFULLY.
SPECIFICATIONS
Item / Model
Manual Lever Pump / 40177
Delivery Volume About 500cc per Stroke
Applicable
Liquids
Diesel oil, Heating oil, Water,
Mineral oil based solvents,
Windshield Washer Fluid, Coolants,
Antifreeze, Agricultural chemicals etc.
Applicable range
of Temperature
About -5°C ~ +45°C
Main Materials
Polypropylene, Polyethylene, Nitril / NBR
OPERATING INSTRUCTIONS
How to assemble the Suction Pipes
1. Thread Suction Pipe B into
Suction Pipe A (Diagram 1-
).
2. Thread Suction Pipe A+B into
Suction Thread Hole
(Diagram 1-
).
3. Adjust the length of Suction
Pipe C to fit it with the height
of the Drum and fix pipes B+C
with Joint Nut (Diagram 1-
).
Length of Assembled Suction Pipes:
• Suction Pipes (A+B+C) 690–980mm.
• Suction Pipes (B+C) 350–640mm.
Note: The Suction Pipes fits a 200L
Drum as well as a 1000L IBC Tank.
How to operate the Pump
1. Insert the Suction Pipes
into the Drum Can and fix
the Pump Head with a
Drum Bung Adaptor
(Diagram 2-
).
2. Place the Pump Head in
the appropiate position
and fix the Pump Head
firmly with the Lock Nut
(Diagram 2-
).
3. Insert the Discharge Hose into the Outlet Spout and fasten
it with a Clip (Diagram 2-
).
4. Stroke the Handle up and down rapidly until liquid starts
pouring. Be careful not to spill the liquid on the ground
when pumping the liquid into the recieving tank (Diagram
2-
).
5. Turn the Air Vent Cap counter-clockwise to stop siphoning
(Picture above
).
CAUTION
Do NOT use one Pump for more than one type of liquid.
• Operate the Handle smoothly to prevent the Pump
Head from getting damaged.
• Do not place the Pump Head upside down, which
would cause the remaining liquid to leak out of the
Discharge Hose.
Diagram 2
Diagram 1
Joint Nut
A
B
C
Find more information at:
www.kabi.dk
Trisure and Mauser
adaptors for Plastic Drums