Kabel Salon Maestro, Быстрый старт

Страница: 6 / 11

4. CLEANING METHODS OPERATION
Since the appliance is cooled with water, the water tank, cooling pads and filters should be cleaned to
maintain peak performance, especially after one use.
dragged on. This cleaning also prevents the formation of bad odors, etc.
The appliance must be maintained and cleaned every 2 weeks to prevent these situations and avoid
damage caused by contamination.
1- Separator Cleaning
The part of the top cover numbered in the diagram above opens. The retractor holes can be cleaned
from time to time with a sharp object. Water mixed with lemon salt can be poured into the upper chamber
to remove limescale.
Since the quality of the water used varies, the water distribution channels can be checked by opening
the top cover from time to time.
2- Dust filter cleaning
The filters indicated with the number 2 in the above diagram are removed by pulling upwards. They are
cleaned by washing them with pressurized water.
As appliance operating environments vary, the condition of the dust filters may be checked from time to
time.
3-Cleaning cooling pads
*The part of the side panel numbered 3 indicated in the diagram is removed by unscrewing the screws.
* The panel support plastics numbered 4 are removed from the slot and the cooling panel is accessed. It
is recommended to clean the cooling panel with pressurized water.
*The water tank on panel number 5 is removed by unscrewing the screws and cleaned.
* The number 6 water hose is removed and cleaned by removing the Screws.
4- Body Cleansing
The body can be cleaned with water without disassembling the appliance. The part of the water tank
number 8 is washed with water. In case of possible lime, the use of lemon salt will ensure the removal of
lime.
NOTE!!!
*** Unplug the appliance during the cleaning process.
*** Before and after cleaning, the parts of the CONTROL PANEL must NOT be wet.