Kaba SIMPLEX 900 Series, Руководство по установке

Страница: 9 / 10

14 13
J-12 Once you have depressed all the digits in this
new combination, turn the control shaft (d)
clockwise (See Figure 10-4) . The code change
button (h) under lockout slide (g), should pop
up (See Figure 10-4) . The combination is now
set back to factory 2 and 4 together, then 3
(this will be evident once you have reassem-
bled the center plate and barrel assembly.
J-13 Look at the code gear pockets (f). The num-
bers in the combination should not be at the
shear line (open position) (See Figure 10-3) .
Reinstallation : Replace the 3-sided dust cover marked “Kaba Simplex.” Make
sure the staked joints on both end plates fit through the slots on the dust
cover. Stake the end 2 plate joints. Replace the combination chamber into the
lock reversing the steps in Section I (I-4 to I-1).
Testing : Enter the factory combination you preset during the reset process.
Turn the outside thumbturn to the right (clockwise). The latch should retract.
If the latch does not retract, turn the outside thumbturn left (counter-clock-
wise) and release, then enter the code again. The code must be changed from
the factory code, using Section H in this book.
K. LEVER HANDLE / PANIC HARDWARE KITS
ASSEMBLY INSTRUCTIONS
K-1 Assemble Part # 24124 Inside Stop (A) to housing with Part # 204112-022
Inside Stop Retaining screw (B). Assembly will be a force fit.
K-2 Assemble Part # 44133 Inside Insert (C). Half moon section of insert
should rotate freely between stopping points of stop (See Figure 11-1) .
K-3 Assemble Part # 34037 (B) Washer over
housing side of insert (See Figure 11-2) .
K-4 Assemble Lever Handle or Panic Hardware
Rocker Arm over insert while lining up Roll
Pin hole (See Figure 11-2) .
K-5 Insert Part # 54166 Roll Pin (C). Assembly
will be a force fit (See Figure 11-2) .
K-6 Test Lever Handle / Panic hardware rocker
arm for rotational free movement.
(A) =
(D) = Inside Housing
Part #74200 - Panic Hardware
Part #44105 - Inside Lever Handle
C
A
B
D
C
A
B
D
11-1
11-2
L. TROUBLESHOOTING
?
Latch/bolt fails to retract when access code is pressed and outside thumbturn is
rotated clockwise.
Buttons were not fully depressed when the access code was entered.
Turn thumbturn counterclockwise to stop position and try to retract the latch/bolt again.
?
Turning outside thumbturn always retracts latch/bolt without depressing any buttons.
Lock is in zero combination.
Follow the procedure for changing the combination in Section H, but omit step H-2.
?
Inside knob only retracts latch/bolt partially or not at all.
Holes were not drilled straight or were not drilled in proper location.
Door thickness is not appropriate for this model.
Recheck the holes and file so lock does not bind.
Make sure correct model was ordered and installed.
?
After setting a new combination, the lock works one time only, then fails to open.
Buttons of intended combination were not fully depressed when changing combination.
This is a lost combination situation. Follow instructions in Section J.
f
g
c (5)
e (5)
h
g
f
d
10-3
10-4
d
For technical assistance please call
1-800-849-TECH (8324) or 336-725-1331