Page 3
Revision level 19.09.2006
Operational Instructions 82021 Code-Combi K - Standard
4)
Enter valid 6-digit primary code
5)
Press P
6)
Press 3
7)
Enter new 6-digit secondary code
/ 2 x
8)
Enter new 6-digit secondary code again
1 x
If the new secondary code as per 8) was incorrectly entered
repeat sequence from 2)
3 x
9)
Test newly programmed secondary code by opening once again
3.5 Alteration of the secondary code by secondary code holder
1)
Open lock with valid 6-digit secondary code (see 3.1)
2)
Press ON
3)
Press P
4)
Enter valid 6-digit secondary code
5)
Enter new 6-digit secondary code
/ 2 x
6)
Enter new 6-digit secondary code again
1 x
If the new secondary code as per 6) was incorrectly entered
repeat sequence from 2)
3 x
7)
Test newly programmed secondary code by opening once again
3.6 Cancellation of the secondary code by primary code holder
1)
Open lock with valid 6-digit primary code (see 3.1)
2)
Press ON
3)
Press P
4)
Enter valid 6-digit primary code
5)
Press P
6)
Press 0
1 x
3.7 Locking
1)
Turn the bar handle counter clockwise until stop position is reached
The bar handle must be turned back in starting position. Please pay attention that the safe will be closed at the same time.
4 Power supply
The lock is supplied with electricity by means of a 9-volt block battery. We recommend using an alkaline/manganese battery
with reduced heavy metal content.
When changing the battery, please dispose of old batteries in an environmentally friendly manner using recycling /collecting
boxes. Batteries should never be thrown on the fire, into water or thrown away with normal household waste.
Insufficient power supply
1)
After pressing ON
10 x
2)
Replace battery without delay
Low voltage is shown to be in evidence if the red LED flashes 10 times after the ON button is pressed. There is still sufficient
energy for opening approximately 50 times, but no further programming sequences should be carried out.
