5
X-09 L
OCK
S
ETUP
Setting up the X-09 lock for operation involves both the operating mode and the
combination(s).
Note:
The lock is shipped preset to operate in the Single Combination Mode
with a factory combination of 50-25-50.
Before you can set a new combination, you must select and set a mode of operation. The
X-09 has three modes of operation:
Single Combination Mode:
The X-09 will open when one three-number combination
is successfully dialed.
Dual Combination Mode:
Two separate combinations are required to open the X-09.
Either combination may be dialed fi rst; however, the operator must begin entering the
second combination within 40 seconds of completing the fi rst combination.
Supervisory/Subordinate Mode or Super/Sub Mode:
Two separate combinations
are required to open the lock, with the Supervisory Combination controlling access
of the Subordinate Combination. The Supervisory Combination must be entered
fi rst to
U
n
L
ock (
UL
) the lock. Once the Supervisory Combination has been entered,
the Subordinate Combination can be used to open the lock at any time during this
“unlocked” state. The Supervisory Combination can be entered again to disable lock
access -
L
ock
U
p (
LU
). In this state the Subordinate Combination will no longer open
the lock.
SET OPERATING MODE AND CHANGE COMBINATIONS
Use the Change Key (Figure 2) provided with your X-09 to set the desired operating mode
and combinations. If at any time during the process you see the Key and Lightning Bolt
symbols displayed, stop the sequence and return to Step 4. If at any time after you start the
change key process, you see only a Lightning Bolt symbol displayed, stop the sequence,
reinsert the change key, and return to Step 4.
Note:
The lock serial number may be used to complete this process if the
current combination has been lost or forgotten and if you can gain access
to the back of the lock.
Using the serial number for this procedure will not open
the lock. It will only allow you to set the new operating mode and combination(s).
When using the serial number to change the combination, you must fi rst create an
error by dialing an incorrect combination.
If you have not read the section on “Dialing the X-09” and “Opening the X-09 (Factory
Combination)”, it is important that you do so before proceeding.
Note:
Use the preset
factory combination
of
50-25-50
to open the lock the fi rst
time. If the container is already open, you may skip Step 1.
1. Open the lock by dialing the current combination(s) and retracting the bolt.
Then remove the container dust cover to gain access to the change key holes on the
back of the lock.
Fig. 2 - Change Key
Содержание 1F
Страница 1: ...OPERATING INSTRUCTIONS X 09TM Type 1F HIGH SECURITY ELECTRONIC LOCK ...
Страница 16: ...NOTES ...
