Kaabo Skywalker 8, Руководство пользователя

Страница: 12 / 14

19 20
DISPLAY &
KEY SETTINGS
3. Power Button. To turn the scooter on or off press button for 2 seconds.
4. Accelerator. Pull to accelerate. The stronger you pull, the faster it
accelerates. The scooter is delivered in “Non-Zero Start” setting
(Kick-And-Go is ON), i.e. the accelerator only works if the scooter is
already in motion.
5. Mode Button. Press to select various display options:
Detailed P-settings mode. To access P-settings to make various advanced
changes, press POWER [3] and MODE [5] simultaneously for 2 seconds.
Cycle through the P-settings using the MODE button. To select a P-setting in
order to make changes press the POWER button. Change the value (up or
down) using the MODE (Up) and POWER (Down) buttons. To return to the
P-settings menu after changing a value, wait 2 seconds. To return to operating
mode, wait a further 2 seconds. Only
COMMENT MODE
TIME
Time since powering on the scooter.
TRIP
Distance travelled since powering on the scooter.
ODO
Total distance travelled.
VOL
Current battery voltage.
CH2:00
Charging mode. Time (2 hours) scooter stays ON (overrides auto-switch off)
so you can use display’s USB port to charge e.g. your phone.
P-SETTINGS
P0
Tire diameter .
P1
Controller shut-down voltage. Default set to 52V .
P2
Motor magnetic pole setting. Default is 30. Do not change.
P3
Speed signal selection. Default is 0. Do not change.
P4
Distance / speed unit. 0=km, 1=miles
P5
Start setting. 1=non-zero start (Kick-and-Go), accelerator won’t work if scooter not in
motion; 0=immediate start (CAUTION while using this!)
P6
Cruise control. 0=cruise control OFF, 1=cruise control ON.
P7
Initial acceleration. 0=strong, 1=soft.
P8
Electric (regenerative) braking (E-ABS). 0=E-ABS off, 1=E-ABS on
P9
Speed limit as % of top speed, i.e. 100=no speed limit.
PA
Clear total distance travelled (ODO).
PB
Scooter auto-turn off time in minutes.
PC
Display brightness (1=low, 3=high)
Driving Mode Selection
Located underneath the main display on the right side of
the handle bar you can find two switches to configure
driving modes:
The ECO/TURBO switch regulates the power of your scooter. By pressing
down the button, ECO mode is activated which will reduce torque and top
speed to maximize range. When the button is not pressed, TURBO mode is
activated and there is no restriction of power.
The SINGLE/DUAL switch toggles single or dual motor drive. By pressing down
the button DUAL motor drive is activated. When the button is not pressed,
SINGLE (rear) motor drive is activated.
For Maximum range, select ECO mode and SINGLE motor drive. For maximum
power and speed, select TURBO mode and DUAL motor drive.
Display Settings
Scooter is equipped with the following display:
Gear change. To change the gear (1=slow, 2=medium, 3=fast), while the
scooter is powered ON, press the POWER button to enter gear setting mode.
Press MODE to switch between gears. To return to operating mode either
press POWER or wait for 2 seconds.
1. Speedometer. Shows the speed at which you are travelling.
2. Battery Indicator. Charge your scooter frequently, do not let it run out
of battery. As a rough guideline, charge at or below 2 bars.