K40 RLS2, Руководство пользователя

Страница: 5 / 20

Wake-Up Sequence
(using factory default settings)
Once your K40 RLS2 has been mounted and had the power
connected, you may begin use immediately by following
these steps:
1. Switch on the RLS2 – Rotate the Power On / Volume
Control Wheel on the left side of the unit.
2. Listen for Wake-Up Sequence – The RLS2 will an-
nounce (voice) and display (screen)
K40 SCAN
then go
through a “wake-up sequence” lasting approximately 5
seconds.
a. You will hear and see all bands report.
b. Upon completion of the “wake-up sequence,” the
screen will display
Highway
(Filter setting).
c. After locating available satellites, the RLS2 will
announce, “GPS Connected,” then display
GPS
.
3. You’re ready to drive! – The RLS2 will now display your
Filter setting, direction of travel, and speed. For example,
if you are driving West at 57 mph / kph and the Filter is on
the Highway setting, the display will show:
H W 57
Want help programming your RLS2?
Call 800.323.5608
5
Filter
HIGHWAY
Travel
Direction
WEST
Speed
57 mph / kph