Quick Start
(using factory default settings)
Once your K40 RL100 has been mounted and had the power
connected, you may begin using immediately by following
these steps:
1.
Switch on the RL100
–
Turn the Power On/Volume
Control Wheel
on the side of the unit.
2.
Wait for Test Scan to complete
– The radar detector
will announce(voice) and display(screen)
K40 SCAN
then
go through a “wake up sequence” lasting approximately
5 seconds.
a. You will hear and see all bands tested. Adjust the
volume during this test.
b. Upon completion of the sequence scan, the screen
will display
HIGHWAY
.
c. After finding available satellites, the unit will announce
“GPS Connected” then display
GPS
.
3.
You’re ready to drive!
– The RL100 will now display
filter setting, your speed and direction of travel. For
example, if you are driving West at 57 mph and the filter
is on Highway setting, the display will show
H W 57
Please read the entire Owner’s Manual to fully understand
all of the RL100’s operations and functions.
5
Filter
HIGHWAY
Travel
Direction
WEST
Speed
57mph
