WARRANTY REGISTRATION
Please fill out and mail the warranty registration card found on the back page of this owner’s manual.
Mail it to the appropriate office listed on the cover of this manual, limited warranty is valid only if the
registration card is completed within (10) days from the day of purchased. You will void any warranty by
not filing the registration card. The warranty registration card requires the boat / Kayak model and the
H.I.N. number (hull identification number). The “Boat Model” refers to the name of the Kayak
(KCC335WM). Along with the size of the boat as designated on the capacity plate. The “H.I.N.” is the
12 (twelve)-character identification number found on the right hand (starboard) side of the Kayak. This
number begins with the letters “SEV”, followed by five numbers, one letter, and then three more
numbers. Example: SEV 12345 A990.The entire number must be entered on the warranty registration
card at the end of this manual.
CAUTION
Make safety a high priority in the use of your Kayak.
Always provide approved personal flotation devices for each passenger. Wear them for safety.
In most areas there are local laws and regulations regarding the use and equipment of small
Boats / kayaks.
A phone call to the local authorities or even the Department of Motor Vehicles will give you the
necessary information. Learn about your Boating / Kayaking area. Ask locals about tides and
currents.
Be careful that you do not over estimate your strength, your endurance or your skill.
Be careful never to under estimate the forces of nature.
Inflation
Before you begin inflation, unfold your new “K2” Kayak in an area that is clean and free of
sharp objects and debris.
For the first inflation and in order to get acquainted with your new Kayak, inflate indoors at room
temperature where the PVC will be soft and assembly process made easier. We have included a high
volume low-pressure bellows pump, we recommend that you carry it with you as it can be stored easily
in the kayak should you need additional inflation later.
Do not use any high-pressure air compressor; you will damage your “K2” Kayak.
Note: Any use of a high-pressure air compressor will automatically void all warranties.
1. Your “K2” Kayak is equipped with 2 Boston valves for the two main, (side) chambers.
2. Please note, the Boston Valve is a two way valve consisting of two parts, the valve insert (center
portion) and the square cap. To inflate, insert the valve (center section with longer threads) into the
valves base on the “K2 Kayak, to deflate, remove the valve insert (center section). The square cap
with rubber gasket makes the valve airtight once it is screwed back on to the valve insert.
3. Inflate the main, (side) chambers until they are free of wrinkles and feel firm to the touch.
4. Next, inflate the floor section. The floor section is equipped with a push in type valve. To inflate,
remove the push-in plug from the valve and inflate the floor section until it’s free of wrinkles and
feels firm to the touch.
2
