K1EL
WKUSB with WinKeyer3 User Manual
WKUSB
WKUSB User Manual
12/20/2017 Rev 1.0
Page 24
This brings up a form that presents the Winkeyer options that can be modified. First thing to do is
click Open. That connects AC Log to WKUSB, the status will change to Open and WKUSB’s
firmware revision will be displayed. Most of the options should be familiar, any that aren’t can be
looked up in Appendix D. Sidetone can be turned off by unchecking Sidetone Enable if you would
rather use your radio’s sidetone.
Click Done and you will return to the CW Setup form, you can enter messages in the F1 through
F11 slots. F1 is set up as a repeating message with adjustable loop delay. When you click Test,
the message in slot F9 will be sent. Click Save Settings to save you configuration and then click
Done to return to AC Log where you can start using WKUSB on air.
