5
Note:
Oil Filler Plug is rubber and located centrally on
the upper portion of the reservoir. See exploded drawing
on page 11.
Figure 3 - Model KTI-63511
release valve
saddle
assembly
tilt adjustment
knobs
position handle
oil filler plug
(not shown)
swivel caster
pump
handle
chain
handle
sleeve
lift arm
ASSEMBLY (KTI-63511)
Refer to figure 3:
Little or no assembly is required. Refer to figure 3 and
the exploded view on page 11 for details in understanding
the assembly and the nomenclature of your product.
BEFORE USE
1. Inspect jack before each use. Do not use if bent,
broken or cracked components are noted. Ensure that
casters move freely. Check for and tighten any loose
assemblies.
2. Verify that the product and the application are
compatible.
3. With ram fully retracted, locate and remove the oil
filler plug/screw. This will help release any pressurized
air which may be trapped within the reservoir. Ensure
the oil level is just below the oil filler plug/screw hole.
Reinstall the oil filler plug/screw.
For KTI-63511 only:
Ensure the oil level is ~3/16"
above the inner cylinder as seen from the oil filler plug
hole.
4. Before initial use, turn vent screw counterclockwise
carefully, but no more than 1 full turn.
5.
KTI-63504 only:
Pour a teaspoon of good quality, air
tool lubricant into the air supply inlet of the lift control
valve (See Fig 1). Connect to air supply and operate
for 3 seconds to evenly distribute lubricant.
Note:
Air actuated product is fitted to accept the popular
1/4"npt air nipple. When installing air nipple, ensure that
thread sealing compound enter the air supply inlet orifice.
Application of thread tape is acceptable, but ensure that
it is not applied beyond the first machine thread.
•
Study, understand, and follow all printed materials
provided with/on this product before use.
•
Do not exceed rated capacity.
•
Use only on hard, level surfaces capable of
supporting rated capacity loads.
•
Use of this jack is limited to the removal,
installation and transportation of transmissions,
transfer cases and transaxles.
•
Do not use a transmission jack to tilt or support a
vehicle.
•
Ensure the center gravity of load is centered on the
saddle.
•
Do not exceed 10
0
tilt angle of the saddle assem-
bly in all directions.
•
Adequately support the vehicle before starting re-
pairs.
•
Use only chains and slings provided.
•
If loaded jack must be moved, make sure that the
load is secured, stable and in lowest position.
•
This is a lifting and lowering device only.
•
Transfer load immediately to appropriate support
device for service or repair.
•
Shock loads may cause the sudden loss of load
and/ or cause the jack to tip or flip over violently,
bend or break.
•
No alterations shall be made to this product
•
Failure to heed these markings may result in
personal injury and/or property damage.
!
WARNING
To avoid crushing and related
injuries:
NEVER work on, under or
around a load supported only
by a jack. Immediately
transfer the load to an
appropriate work station.
!
WARNING
• Leer, comprender, y seguir las instrucciónes antes de
utilizar el aparato.
• El manual de instrucciónes y la información de
seguridad deben estar comunicado en lengua del
operador antes del uso.
• No seguir estas indicaciónes puede causar daños
personales o materiales.
!
ADVERTENCIA
