KTI-63105A
3
SETUP
1. Remove 2-piece handle from box. Insert narrow portion of top handle into bottom handle, align top and bottom bolt holes, and secure
with handle bolt provided.
2. Unscrew the handle set screw #27 so that it will not interfere with the insertion of the handle in the handle socket. Insert the handle in
Secure the handle in the handle socket by tightening the handle set screw.
3. Sometimes air gets trapped in the hydraulic system during shipping and handling. If the pump feels spongy, or there is not a full
incremental pump stroke, or the jack will not raise to maximum height, follow these instructions in order to purge air from the system:
a.
With the lift arm in its completely retracted position and the pump handle rotated all the way in a clockwise direction until it
stops, rotate the pump handle in a counterclockwise direction two full revolutions.
b.
Proceed to pump the jack 15 full incremental pump strokes.
c.
Rotate the pump handle clockwise until it stops and proceed to pump the handle until the lift arm reaches maximum height.
d.
Repeat steps "A" through "C" until all air is purged from the system.
Any jack which appears to be damaged in any way, is found to be badly worn, or operates abnormally MUST BE REMOVED FROM SER-
VICE until necessary repairs are made.
INSPECTION
Handle
Bolt
Handle
Handle
Socket
Upper Handle
Bolt Hole
Lower Handle
Bolt Hole
Lower Handle
Chassis
Rear
Casters
Front
Wheels
Saddle
Lift Arm
