KTI-XD63105
3
rev. 12/24/20
SETUP
1. Remove 2-piece handle from box. Insert narrow portion of top handle into bottom handle, align top and bottom bolt holes, and secure
with handle bolt provided.
2. Unscrew the handle set screw #18 so that it will not interfere with the insertion of the handle in the handle socket. Insert the handle in
the handle socket and rotate the handle assembly back and forth until the release valve fits in the receiver in the bottom of the handle.
Secure the handle in the handle socket by tightening the handle set screw #18.
3. Sometimes air gets trapped in the hydraulic system during shipping and handling. If the pump feels spongy, or there is not a full
incremental pump stroke, or the jack will not raise to maximum height, follow these instructions in order to purge air from the system:
a.
With the lift arm in its completely retracted position and the pump handle rotated all the way in a clockwise direction until it
stops, rotate the pump handle in a counterclockwise direction two full revolutions.
b.
Proceed to pump the jack 15 full incremental pump strokes.
c.
Rotate the pump handle clockwise until it stops and proceed to pump the handle until the lift arm reaches maximum height.
d.
Repeat steps "A" through "C" until all air is purged from the system.
Visual inspection should be made before each use of the jack, checking for leaking hydraulic fluid and damaged, loose or missing parts.
Any jack which appears to be damaged in any way, is found to be badly worn, or operates abnormally MUST BE REMOVED FROM SER-
VICE until necessary repairs are made.
Saddle
Chassis
Lift Arm
Handle
Bumper
Handle
Bolt
Handle
Handle
Socket
Handle
Socket
Handle
Rear
Casters
Handle
Bolt
Upper Handle
Bolt Hole
Lower
Handle
Bumper
Lower Handle
Front
Wheels
Lower Handle
Bolt Hole
INSPECTION
