11
This menu is to select frequency of Roger Beep. The frequency range
is 300KHZ—3KHZ. The shift step is 10HZ.
Default:
1050HZ
(11) RBT (ROGER BEEP Holding Time)
This menu is to select Roger Beep Holding Time from 50ms—1000ms.
The shift step is 50ms.
Default:
500ms
(12) CFR (CW Side Tone Frequency)
This menu is to select CW Side Tone Frequency from 300HZ-3KHZ,
the shift step is 10HZ.
Default:
1050HZ
Rotate the VOLUME knob to set a comfortable listening level.
31
SET the MODE switch to the desired mode.
41
Set the CHANNEL selector switch to select the desired channel.
51
Set the RF gain control full clockwise to maximum RF gain.
61
Listen to the background noise from the speaker. Turn the
71
SQUELCH control clockwise slowly until the noise disappears (no
signal should be present). Leave the control at this setting. The
Squelch is now properly adjusted. The receiver will remain quiet
until a signal is actually received. Do not advance the control too
far, or some of the weaker signals can not be heard.
OPERATING PROCEDURE TO TRANSMIT
Select the desired channel of transmission.
11
Press the Push-To-Talk switch on the microphone and speak in a
21
normal voice.
(13) TON (Transmitting Single-Tone Frequency)
his menu is to select Transmitting Single-Tone Frequency from 300HZ-
3KHZ. The shift step is 10HZ.
Default:
1050HZ
OPERATING PROCEDURE TO RECEIVE
Be sure that power supply, microphone and antenna are connected
11
to the proper connectors before going to the next step.
Turn the radio on by tuning VOLUME control clockwise.
21
