Care and maintenance
Read the following recommendations carefully before using BTR017N.
Following these you will be able to enjoy this product for many years.
Keep it dry and don’t put it in the dump place to avoid the product’s
internal circuit being affected.
Keep the product away from direct sunlight or hot places. High
temperatures will shorten the life of electronic devices, destroy the
battery or distort certain plastic part.
Don’t expose the product to cold areas. It may damage the internal circuit
board.
Don’t try to disassemble the product as it may get damaged if you are not
professional.
Don’t let it fall down onto the floor or other hard surfaces. The internal
circuit might get damaged.
Don’t use intensive chemical products or detergent to clean the product.
Don’t scratch the surface with sharp things. It may get damaged by
sweat.
Please don’t attempt to take out the battery from the receiver, as this
might damage it.
In case the receiver doesn’t function properly, send it to the store you bought
it. The staff will help you to solve the problem.
FAQs
1.
What to do when BTR017N can’t be turned on?
a)
Please charge the BTR017N.
b)
The battery will enter the sleep mode if the BTR017N hasn
’
t been use for
a long time. Then the red LED will on after charging for 30 minutes.
2.
What to do when BTR017N can’t pair and connect to a Bluetooth
device?
a)
Make sure the Bluetooth device is placed within 5 meters;
b)
Ensure BTR017N has entered pairing mode.
3.
What to do when BTR017N can’t be turned off?
Please charge the BTR017N for about 2 seconds.
7
Specifications
Bluetooth version
Bluetooth V4.0
Bluetooth profiles
A2DP and AVRCP
Bluetooth frequency range
2402MHz-2480MHz
Operating distance
About 10 meters
Charging input voltage
DC 5V
Working time
About 12 hours
Charging time
About 2 hours
FCC Warring
Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
