Operating instructions K-Laser Blue Dental Rev. ZE
Page 8 of 72
Warning
Never direct the laser beam toward paper, plastics or objects with dark surfaces. They could
catch fire due to the high temperatures produced by the laser beam.
Caution
Avoid interference between the laser emission and any optical sensors of devices operated in
the vicinity of the device.
Caution
Do not place the unit near heat sources. Do not cover the convection openings for air cooling
on the sides of the unit.
Caution
The device may be operated only by authorized personnel. In order to prevent false or
improper use, the device must not be used by unauthorized persons. Do not write down the
electronic access key somewhere else in order to reduce risk of misuse of the laser by
unqualified persons. Please turn off the unit after the use.
Warning
Set up the laser unit properly and completely before putting it into operation.
Warning
Make sure that the electrical system is equipped with the required devices for protection
against direct and indirect contact (thermomagnetic switches, residual current circuit breakers)
and has been set up by a qualified electrician in compliance with the applicable standards.
National directives regarding electrical installations must be observed.
Warning
Verify that the line voltage corresponds to the voltage indicated on the rating plate of the
adapter or in the technical specifications.
Warning
Do not use the device if a visual inspection shows that it has been damaged.
Warning
If you accidentally spill any liquid on the unit, immediately stop treatment, disconnect the power
cable and contact your local depot or your authorized service center for assistance.
Caution
Never under any circumstances try to disassemble the device. This is limited exclusively to
trained and authorized personnel.
Caution
Switch the device OFF immediately in case of fiber breakage.
Caution
The use of this device close to or over (above or under) other devices must be forbidden
because an improper functionality could happen. If needed to do this, the unit and the other
ones must be maintained under control to verify the correct functionality.
Caution
The device may only be operated with the Sinpro MPU101-106 power supply and the power
cable provided.
Operation with other power supplies may result in failure or destruction of the laser unit and the
use of power cables not provided by Eltech K-Laser can compromise the conformity of the
device regarding emissive requirement and immunity. If any power supply, power cable or
accessory other than the one recommended is used, the approval of the entire unit
automatically becomes void and the warranty expires.
Caution
The use of accessories, transductors or power cables not provided by the manufacturer of the
device, could increase the electromagnetic emission and decrease the electromagnetic
immunity of the device.
