User information
Angled mincer WW 130/160
WWD130
10.06.2022
Speicherdatum 10.06.2022 11:53:00
Seite 8
2.7
Installation of the machine
Installation and commissioning should be done by K+G WETTER
customer service or a qualified contractor. The meat mincer is
delivered completely assembled and ready for operation. At the
location, the machine can be transported on a lift cart or a fork lift.
Before setting the machine down, remove the wooden transport
pieces and screw in the 4 machine feet. The gross weight of the
meat mincer is 810 kg.
To level the meat mincer, place a spirit level on the funnel and level
the machine by adjusting the height of the rubber feet. Finally, lock
the feet in place with the lock nuts.
2.8
Electrical connection
The machine may only be connected to the mains by a
qualified electrician.
The machine is delivered with a 4 m cable. The electrical equipment
is in accordance with EN 60 204-1 and is depicted in the enclosed
circuit diagram. The electrical connection should be carried out
according to the technical specifications on the identification plate
and in Chapter 1. The cable diameter must be determined
according to the fuse in the cable. Neutralisation, earthing, residual
current or overcurrent release protection should be installed
according to the conditions on site.
2.9
Tests before commissioning
The following tests are required before commissioning:
Checking mains voltage and frequency
Check the mains voltage and frequency by comparing the
indications on the electric company counter with the indications on
the machine plate. Inform customer service if they do not
correspond.
The voltage variations may not be larger than + 10% and - 5%.
Malfunctions and premature wear may be expected with larger
deviations. The guarantee provisions do not apply in this case.
The rotational direction of the worm must be checked as follows:
- Switch on meat mincer without cutter assembly or
worm using the the key.
- The worm drive pin must turn in the
counterclockwise direction when viewed through the
discharge guard and the worm housing.
- If the rotational direction of the worm is incorrect, the
poles of the conncting line must be reversed by a qualified
electrician.
- The prescribed daily safety inspection must also be carried out
(see chapter 3.3).
2.10 Area of application
