8
Replacing the Blades
WARNING – Blades are sharp! Use leather gloves when handling blades.
1) Set the drill to neutral or remove the battery from the drill for your own safety.
2) Remove the center tip blade with 3/16” Allen wrench.
3) Remove the outside chipper blades with 7/16” open end wrench.
4) Replace the outside chipper blades and snug the bolts into
position. Then torque an additional 1⁄4 turn and STOP!
(If possible torque to 115 in/lbs)
5) Replace the center tip. Adjust the blade so it is equally
spaced side-to-side from the chipper blades installed in
the previous step.
IMPORTANT - The center point blade when being re-installed needs to be
centered between the two main chipper blades. The unique two stage point may look like
a broken tip but it is designed this way.
CAUTION - DO NOT OVER TIGHTEN as it will strip the threads and this will
not be covered under warranty.
6) Torque bolt of center tip to 115 in/lbs.
K-Drill Extension Installation
The standard K-Drill can drill through up to 36” of ice. The K-Drill extension can
be added for thicker ice conditions. Extensions can be “stacked” if needed to create
a very long ice auger.
1) Slide the down float, exposing the Allen bolt.
2) Remove the bolt and remove the drive adapter with washer.
3) Install the stem of extension. Replace and tighten bolt removed in step #2.
4) Install the driver adapter with washer into top of extension. Secure it with the
bolt provided.
#IDRLEXT - 12 “ Auger Extension
