KNX/EIB
Switch Actuator with Secure
35
4.4.5. Parameter window “X: Threshold”
The window in Fig. 4.4.5 will be shown up when the parameter “Function of ‘threshold’ for switch”
is enabled in Fig. 4.4(2).
Fig. 4.4.5 Parameter window “X: Threshold”
The object “Threshold input” of 1Byte is enabled when activating the threshold function.
It will trigger the switch to make one operation if the value of the object “Threshold input” is lower
or more than the default threshold.
There are 2 individual thresholds are ready to use always and the “Threshold 1 value” is set by the
bus.
Parameter “Threshold 1 value”
Parameter “Threshold 2 value”
These two parameters define the value of threshold 1 and threshold 2. Options:
0...255
It must to meet the condition Threshold 1<Threshold 2, if not, you can not configure in ETS:
Parameter “Threshold 1 can be changed via bus”
This parameter defines whether change the threshold value by bus or not.
