K-array KM8, Руководство пользователя, Страница: 5 / 6

USER'S MANUAL P. 5
16. TECHNICAL DATA
New materials and design are introduced into existing products without previous notice.
Present systems may differ in some respects from those presented in this brochure.
Notes for data
1. Power handling is measured following AES standard conditions: transducers driven continuously for two hours with a band-limited noise
signal having 6 dB of crest factor.
2. Max power is the maximum RMS applicable power for a musical signal, the referement signal is the one proposed by EIAJ standard.
3. Recommended maximum operating frequency range. Response depends on loading conditions and room acoustics.
4. Free field measured with 1/3 octave frequency resolution at 2 mt.
5. Measured@4 mt then scaled@1 mt.
6. Measured with audio source @1 mt.
7. This is the frequency in which the transducers produce the same sound pressure level (measured@2 mt).
8. Amplifier wattage rating is based on the maximum unclipped burst sine wave RMS voltage that the amplifier will produce into the nominal
load impedance .
Acoustics
Power handling
Max power
Impedance
Operating frequency range
Frequency range
SPL 1W/1mt
Maximum SPL
Coverage
Horizontal
Vertical
Cross over
Type
Frequency
Transducers
Low - Mid frequency
High frequency
Power Audio Input
Connectors
Wiring
Selection Switches
Circuit
Power Input
Connectors
Recommended Amplifiers
Single ended mode
Bridge mode
Physical
Measures
Weight
600 W
65 Hz - 19 KHz +/- 3dB (preset relating)
96 dB (low-mid)
124 dB continuos - 130 dB peak
1
2
4
7
1000 W
50 HZ - 20 KHz +/- 3dB (preset relating)
20°(single unit) - array dependent
100°
Passive high-grade 18 dB/oct.
1.5 KHz
8" Neodymium speaker with 3" voice coil
Two Neodymium drivers with 1.75" voice coil on 4”x1” wave-guide
Two x 4 poles SPEAKON
CH A (1+ / 1-) - CH B (2+ / 2-)
CH A/CH B wiring mode possibility
2 x Speakon IN/OUT
KA10, KA15 and KA40 to drive till 3 units of KM8 each channel
KA10 to drive one unit each amplifier
26 x 28 x 35 cm
10 Kg
10 W
3
5
6