jWIN JL-CD808, Инструкция по эксплуатации

Страница: 3 / 9

2
P R E P A R A T I O N F O R U S E
Remove the stereo carefully from the box, retaining the packaging for future use.
Read these instructions carefully before use.
AC P
O W E R
O
P E R A T I O N
Unravel the AC cord and connect it to a convenienty located AC outlet.
Press the STANDBY button to switch the unit on or off.
The Clock Display will show 12:00 and needs to be set.
If the AC cord is disconnected or if there is a power failure, the
electronic clock is designed to continue operating internally
(without showing the time on the Clock Display) with a 9 volt
battery (not included). To install the battery, slide down the
compartment cover at the back of unit) to open. Then, connect
the battery to the terminals of the battery snap inside the
compartment (use of an alkaline battery is recommended) and
slide the battery compartment cover back into place.
Be sure to check the condition of the battery periodically by disconnecting the AC cord and
connecting it again 2 or 3 minutes later. The preset times should continue operating. If the
clock resets to
]
12:00
^
on the Clock Display, it indicates the battery is dead or not
connected properly.
B
ATTERIES
P
RECAUTIONS
Follow these presautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the
battery compartment. Reversed batteries may cause damage to the device.
3. If the device is not to be used for a long period of time, remove the batteries to prevent
injury from possible battery leakage.
L I S T E N I N G T O T H E R A D I O
O
PERATION
m
Press the STANDBY/ON button to turn the unit on, the STANDBY/ON LED indicator will
light.
m
Silde the FUNCTION switch to the desired band (AM or FM) and tune a station by
turning the TUNING control.
m
When a strong FM stereo signal is received while listening to FM, the FM ST indicator
will light and the sound will be heard in stereo.
m
Adjust the VOLUME control as desired.
A
NTENNA
For FM reception there is a built-in one-meter FM aerial wire at the rear of the unit. Unravel
the wire and move it around to obtain the best reception. For MW reception the signals are
picked up through the built-in ferrite antenna. You may have to move the unit to obtain the
best reception.
9V
A C O u tle t
A C P lu g