![jWIN JG-MRS42 Скачать руководство пользователя страница 5](http://html1.mh-extra.com/html/jwin/jg-mrs42/jg-mrs42_owners-manual_2037115005.webp)
Belt clip installation
•
Removing the belt clip
1. Remove battery cover as shown on Figure 2.
2. Pull the belt clip latch away from the battery cover.
3. Slide up the belt clip while pulling the belt clip latch.
4. Replace battery cover till it clicks.
•
Installing the belt clip
1. Remove the battery cover as shown on Figure 2.
2. Slide the belt clip into the till it clicks.
3. Replace the battery cover till it clicks.
Figure 2: Removing belt clip
Turn the radio on
1. Turn the power/volume knob clockwise. The radio will beep
and the LCD displays ready saved channel settings.
2. Turn the power/volume knob counter-clockwise until the radio
clicks to turn the radio off.
Adjust volume
1. Press and hold monitor button, and rotate power/volume knob
till reaching desirable volume level.
2. Release monitor button.
Set the channel
1. The GMRS radio has 15 channels and 38 CTCSS channels.
2. Press scroll up/down key to set the channel you wish to
communicate.
3. Refer to Menu/Scan section if you would like to set CTCSS
channel.
4. Default setting is channel 1 and CTCSS 0.
Receiving a Call
1. The radio is continuously in receiving mode when powered on.
2. Incoming signal can be heard only when both (transmitter &
receiver) radios are on the same channel & CTCSS.
3. The RX LED will light up in
amber
when incoming signal is
encoded with CTCSS. Otherwise the RX LED will light up in
green
.
Transmitting a Call
1. Press and hold the
push-to-talk
button, and speak gently into
the microphone about 3 inches away from the radio.
2. The TX LED will light up in
red
.
3. Release the push-to-talk button when finished transmission.