1-10 (No.XA014)
SECTION 3
DISASSEMBLY
There is a part different from the photograph according to the model and the destination though explains this disassembly method
by using XV-N30BK for U.S.A.
3.1
Main body section
3.1.1
Removing the top cover (See Figure 1)
(1) Remove the two screws
A
attaching the top cover on both
sides of the main body.
(2) Remove the three screws
B
attaching the top cover on the
back of the main body.
(3) Raise the both sides and lower part of the rear of the top
cover, with opening them slightly in an outward direction.
And the top cover will be removed.
Fig.1
3.1.2
Removing the front panel assembly (See Figure 2, Figure 3, Figure 4)
• Prior to performing the following procedure, remove the top
cover.
• There is no need to remove the mechanism assembly.
(1) Insert a kind of screwdriver in a hole located in the right
side of mechanism assembly, and push a lever until it can-
not be inserted any further.
(2) And then, a tray will come out. Remove the tray in an upper
direction, with slightly opening the lower part of fitting in an
outward direction.
(3) Disconnect the card wire from connector
CN901
on the
power supply board.
(4) Hook
a
and
b
are removed respectively, and the front panel
assembly is removed.
Fig.2
Fig.3
Fig.4
B
B
B
A
x
2
TOP COVER
TOP COVER
TOP COVER
Front panel assembly
Mechanism assembly
Tray
Fitting
Hole and lever
Push
Push
CN901
Front panel assembly
Power supply board
Hook a
Hook a
Hook b
Hook b
Front panel
assembly
Содержание XV-N30BK(MK3)
Страница 33: ... No XA014SCH 2 7 MEMO ...