XV-521BK/523GD/525BK/421BK
1-12
It is not necessary to remove the traverse
mechanism unit.
Solder soldering d on the flexible board next to the
pickup unit.
From the bottom of the traverse mechanism unit,
disconnect the flexible wire from CN10 on the pickup
board.
1.
2.
Remove the screw C attaching the shaft stopper (R)
on the upper side of the traverse mechanism unit.
Pull the side of the shaft stopper (R) outward to
release the joint e and remove it upward. Remove
the skew spring at the same time.
Move the shaft in the direction of the arrow to release
it from the part f.
Release the joint g with the shaft and remove the
pickup with the shaft.
Pull out the shaft.
Remove the screw D attaching the switch actuator.
3.
4.
5.
6.
7.
Removing the pickup (See Fig.5 to 9)
Disconnecting the flexible wire without
soldering may cause damage to the
pickup.
ATTENTION:
Fig.5
Fig.6
Fig.7
Fig.8
Fig.9
Pickup unit
Flexible board
Flexible wire
Pickup unit
Shaft stopper (R)
Shaft stopper (R)
Shaft stopper (R)
Skew spring
Shaft
Shaft
Shaft
Pickup
Switch actuator
Shaft
Joint g
Joint e
Part f
Pickup board
CN10
d
C
C
D
Содержание XV-421BK
Страница 33: ...XV 521BK 523GD 525BK 421BK 1 33 NJM78M05FA IC953 Regulator 1 Terminal layout 2 Block diagram ...
Страница 52: ...6 5 4 3 2 1 B C D E F G H I J A 7 XV 521BK 523GD 525BK 421BK 2 11 Voltage value section ...
Страница 54: ...6 5 4 3 2 1 B C D E F G H I J A 7 XV 521BK 523GD 525BK 421BK 2 13 bottom side ...
Страница 55: ...6 5 4 3 2 1 B C D E F G H I J A 7 XV 521BK 523GD 525BK 421BK 2 14 DVD Servo suface side bottom side ...