7
AM (MW) antenna
1
Connect the AM (MW) loop antenna to the
AM LOOP terminals as illustrated.
2
Turn the AM (MW) loop antenna until you
have the best reception.
To connect an outdoor AM (MW) antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. The AM
(MW) loop antenna must remain connected.
For better reception of both FM and AM (MW)
• Make sure the antenna conductors do not touch any other
terminals or connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
Connecting Speakers
To connect speakers
You can connect the speakers using the speaker cords.
1
If the cords are covered with insulation,
remove a short section of insulation at the
end of each cord by twisting and pulling it
off.
2
Hold the clamp of the speaker terminal.
3
Insert the end of the speaker cord into the
terminal.
Match the polarity of the speaker terminals: red cord to
ª
and black cord to
·
.
4
Release your finger from the clamp.
IMPORTANT:
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
• DO NOT connect more than one speaker to one
speaker terminal.
RIGHT
LEFT
SPEAKERS
1
2
3,4
ANTENNA
2
1
Vinyl-covered wire
(not supplied)
AM (MW) loop antenna
(supplied)
Speaker
cord
Speaker
cord
Right speaker
Left speaker
Getting Started
(continued)
Do not connect the AC power cord until all other
connections have been made.
06_08_UX_S57[B]f.p65
04.3.16, 8:25 PM
7
