1-10 (No.MB514)
3.1.6 Removing the CD mechanism assembly
(See Fig.7)
(1) Disconnect the connector wire from spindle motor connect-
ed to connector
CN602
of CD and micon board.
(2) Solder to short land section of flexible wire and then dis-
connect the flexible wire of pickup connected to connector
CN601
of CD and micon board.
Caution:
• Solder the short land section at the flexible wire of pickup be-
fore disconnecting the flexible wire from the connector on
the CD and micon board. If the flexible wire is disconnected
without attaching solders, the pickup may be destroyed by
static electricity.
• When attaching the CD pickup, be sure to remove solders
from the short land section after connecting the flexible wire
to the connector on the CD and micon board.
Fig.7
3.1.7 Removing the side panel assembly
(See Fig.8)
(1) Remove the three screws
F
attaching the side panel as-
sembly from back side.
(2) Disconnect the card wire from tuner pack connected to
connector
CN911
of power and audio board.
Fig.8
Short land
CN602
CN601
CN911
F