JVC TK-C720TPE, Руководство по обслуживанию

Страница: 10 / 48

2-4
2.4.3 What is “Initial Data”
The initial data loaded at “2.5 INITIALIZE” consists of preset
adjustment values. Therefore, once the adjustment procedure
is started, all adjustment should be done from beginning to the
end. Otherwise, the preset adjustment values would be written
as the adjustment data.
2.4.4 How to write adjusted data to EEPROM in camera
The adjustment values are written in the EEPROM of the cam-
era when you click “YES” from the “Are you sure to write
EEPROM?” message box which is displayed at the end of the
adjustment.
2.4 NOTES
2.4.1 Installation
To install the adjustment program, perform the following proce-
dure.
1) If you have any programs currently installed in the serial I/O
port, remove them.
2) Insert the adjustment program diskette into a floppy diskette
drive.
3) From Windows 95, select “Run” from the “Start” button
and type “a:\setup (or b:\setup)” depending on which drive
contains the diskette.
4) Follow the instructions on the screen.
2.4.2 How to adjusting the EVR
Click the “
䊱
” or “
䊲
” button to the right of the adjustment
items displayed on the screen to adjust EVR to the required
value.
If you abort the adjustment in the middle, the adjustment
values in the camera are not changed (the adjustment val-
ues which have been set before the start of the adjustment
remain unchanged).
These buttons
2.4.5 The test points on the PRO board
PRO board
TP203
TP202
TP201
TP200
TP204