(No.MB040)1-17
3.3.10 Removing the spindle motor board
(See Figs.13 and 14)
• Prior to performing the following procedures, remove the DVD
servo board, clamper base and DVD traverse mechanism as-
sembly.
(1) From the top side of the DVD traverse mechanism assem-
bly, remove the feed motor wire that is soldered to the spin-
dle motor board. (See Fig.13)
(2) From the bottom side of the DVD traverse mechanism as-
sembly, remove the three screws
G
attaching the spindle
motor board. (See Fig.14)
Fig.13
Fig.14
Remove the solders.
DVD traverse mechanism assembly
Spindle motor board
Feed motor
wire
G
G
DVD traverse mechanism assembly
Содержание TH-A85 Series
Страница 26: ...1 26 No MB040 SECTION 5 TROUBLESHOOTING This service manual does not describe TROUBLESHOOTING ...
Страница 27: ... No MB040 1 27 ...
Страница 42: ...2 12 DVD servo section 4 4 Voltage value ...
Страница 75: ...3 25 MEMO ...