EN
41
* The default setting is
bold
in the table below.
This function allows you to record on VHS tapes with S-VHS picture quality. Tapes recorded
using this function can be played back on a VCR equipped with the S-VHS ET function. The S-
VHS indicator lights up on the front display panel when “S-VHS ET” is set to “ON”.
NOTES:
●
Before recording, make sure that ”V. CALIBRATION” is set to “ON” (
墌
page 36).
●
You cannot activate the S-VHS ET function...
– while recording is in progress.
– while timer-recording or Instant Timer Recording (
墌
page 22) is in progress.
– while Video Calibration (
墌
page 36) is in progress.
●
S-VHS ET does not work with S-VHS tapes.
●
To keep the highest quality recording and playback pictures over a long period of time, S-VHS
recording on S-VHS tapes is recommended.
●
Use of high grade tapes are recommended for S-VHS ET recordings.
On some tapes, picture quality will not improve even if the S-VHS ET function is used. Check the
recording quality before you start important recordings.
●
You can play back S-VHS ET recordings on most of S-VHS VCRs and of VHS VCR equipped with
SQPB (S-VHS QUASI PLAYBACK) function. (Notice some VCRs are not compatible with this
function.)
●
While playing back a tape recorded with this function on some tapes, noise may appear. (If playback
picture becomes blurred or interrupted, use a cleaning cassette.)
●
During special effect playback (
墌
page 13), noise may appear. If special effect playback is performed
frequently on a tape recorded with this function, the tape may be damaged and picture may be
deteriorated.
When this function is set to “OFF”, only “:” appears on the front display panel.
NOTE:
Even if you set “DISPLAY” to “OFF”, each item appears on the front display panel in the following
cases;
●
when you press [REC (
¶
)] twice for the ITR (
墌
page 22).
●
when you set the remote control code (
墌
page 46).
●
when you press [DISPLAY], the current status appears for a few seconds.
䡵
“
S-VHS ET
”
“
ON
”
“
OFF
”
䡵
“
DISPLAY
”
“
ON
”
“
OFF
”
–
