Masterpage:Right+
Filename [TH-R1R3EU_05Name.fm]
Page 14Monday, 28 March 2005 21:23
INSTALLING YOUR NEW UNIT
14
●
When you connect speakers other than the supplied ones, use
speakers of the same speaker impedance (SPEAKER
IMPEDANCE) indicated near the speaker terminals on the rear of
the powered subwoofer.
●
DO NOT connect more than one speaker to one speaker
terminal.
Precautions for daily use
●
When moving the speakers, do not pull the speaker cords;
otherwise, the speakers may fall over, causing damage or injury.
●
Do not reproduce sounds at so high a volume that they are
distorted; otherwise, the speakers may be damaged by internal
heat build-up.
●
When holding a speaker, always grasp the lower portion. (TH-R3)
●
Do not lean against the speakers, as the speakers could fall
down or break, possibly causing an injury. Especially make sure
that children do not lean against them. (TH-R3)
Connecting The Satellite (Front, Centre, Surround) Speakers
4
16
TH-R3
4
16
TH-R1
Before connecting the speaker cords;
Twist and pull the insulation coat off and remove.
Front speakers
SP-THS55F
Powered subwoofer SP-PWR1
Centre speaker SP-THS55C
Surround speakers
SP-THS55S
●
Connect the black cords to the black (
) terminals.
●
Connect the white cords to the (
) terminals
referring to the table below:
FRONT SPEAKERS (LEFT)
White
FRONT SPEAKERS (RIGHT)
Red
CENTRE SPEAKER
Green
SURROUND SPEAKERS (LEFT)
Blue
SURROUND SPEAKERS (RIGHT)
Grey
Speaker cord
Centre speaker
SP-THS66C
Surround speakers
SP-THS66S
Front speakers
SP-THS66F
Powered subwoofer
SP-PWR3
White
Black
Black
Red
4 m
10 m
The satellite speakers are equipped with their speaker cords attached directly to their speaker unit instead of
having speaker terminals on their cabinet.
4 m
10 m
4 m
4 m
TH-R1R3EU_00.book Page 14 Monday, March 28, 2005 9:23 PM
