RX-8012PSL
1-7
Prior to performing the following procedure, remove
the top cover and relay board.
Cut off the tie band if needed.
Disconnect the card wire from the connector CN402
on the power supply board.
Disconnect the harness from the connector
CN55/CN56 on the power trans1 board (see fig.17).
Remove the three screws O attaching the power
supply board and pull out the power supply board
removing the hook.
Unsolder three solder parts on the power supply
board.
1.
2.
3.
4.
5.
Removing the power supply board
(See Fig.18)
Prior to performing the following procedure, remove
the top cover and rear panel.
Unsolder seven solder parts on the power/fuse board.
Remove the screw N attaching the power/fuse board.
1.
2.
Removing the power/fuse board
(See Fig.17)
Prior to performing the following procedure, remove
the top cover, front panel assembly and power supply
board.
Disconnect the harness form the connector CN881on
the main board (see fig.13).
Remove the nut fixing the headphone jack.
Remove the screw P attaching the bracket and
remove the bracket.
Drawn out the headphone jack board in the direction
of an inner side.
1.
2.
3.
4.
Removing the headphone jack board
(See Fig.18 and 19)
Prior to performing the following procedures, remove
the top cover.
Disconnect the harness from the connector CN55
/CN56 and CN811 on the power trans1 board.
Unsolder seven solder parts on the power trans2
board .
Remove the four screws M attaching the power
transformer.
1.
2.
3.
Removing the power transformer
(See Fig.17)
Fig.18
Fig.19
Nut
Bracket
Headphone
jack
Headphone jack
Headphone jack board
Tie band
P
(fixing the
earth wire form
the front panel
assembly)
Solder part
Hook
Tie band
O
O
O
Power supply board
CN402
Fig.17
Power
supply board
CN55/CN56
CN811
Power
transformer
M
Solder part
M
Solder part
N
Power/fuse
board
Power cord
Power
trans1 board
Power
trans2 board
Содержание RX-8012PSL
Страница 27: ... M E M O ...
Страница 51: ...RX 8012PSL 3 2 M E M O ...