ELECTRICAL CONNECTIONS
2
A
Typical connections
Before connecting:
Check the wiring in the vehicle carefully. Incorrect connection may cause serious damage to this receiver.
The leads of the power cord and those of the connector from the car body may be different in color.
1
Connect the colored leads of the power cord in the order specifi ed in the illustration below.
2
Connect the antenna cord.
3
Finally connect the wiring harness to the receiver.
B
Connecting the external amplifi er
You can connect an amplifi er to upgrade your car stereo system.
• Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this receiver.
•
Disconnect the speakers from this receiver, connect them to the amplifi er. Leave the speaker leads of this receiver unused.
Signal cord (not supplied for this receiver)
Front speakers
Rear speakers
JVC Amplifi er
Remote lead
Y-connector (not supplied for this receiver)
Remote lead (Blue with white stripe)
To the remote lead of other equipment or automatic antenna if any
*
2
Before checking the operation of this receiver
prior to installation, this lead must be connected,
otherwise power cannot be turned on.
Line out (see diagram )
Rear ground
terminal
15 A fuse
Antenna terminal
Black
Blue with white stripe
Red
Yellow
*
2
*
1
Not included for this receiver
To metallic body or chassis of the car
To a live terminal in the fuse block connecting to the car battery
(bypassing the ignition switch) (constant 12 V)
Ignition switch
Fuse block
To an accessory terminal in the fuse block
To the automatic antenna if any (250 mA max.)
Left speaker (front)
Right speaker (front)
Left speaker (rear)
Right speaker (rear)
Purple
Purple with black stripe
Green
Green with black stripe
Gray
Gray with black stripe
White
White with black
stripe
*
3
Firmly attach the ground wire to the metallic body
or to the chassis of the car—to the place not coated
with paint (if coated with paint, remove the paint
before attaching the wire). Failure to do so may
cause damage to the receiver.
To the remote lead of other equipment (200 mA max.)
Blue
To CD changer or another external component (see diagram )
C
Connecting other external components
CD changer
JVC CD changer
Signal cord supplied for your CD changer
CAUTION
• Before connecting the CD changer,
make sure that the receiver is turned off.
External component
CD changer jack
KS-U57
*
3
Signal cord (not supplied for this receiver)
*
3
Line Input Adapter KS-U57 (not supplied for this receiver)
External component
To prevent short circuits, we recommend that you disconnect the battery’s negative terminal and make all electrical connections before installing the receiver.
•
Be sure to ground this receiver to the car’s chassis again after installation.
Notes:
• Replace the fuse with one of the specifi ed rating. If the fuse blows frequently, consult your JVC car audio dealer.
• It is recommended to connect to the speakers with maximum power of more than 50 W (both at the rear and at the front, with an impedance of
4
Ω
to 8
Ω
). If the maximum power is less than
50 W, change “AMP GAIN” setting to prevent the speakers from being damaged (see page 20 of the INSTRUCTIONS).
• To prevent short-circuit, cover the terminals of the UNUSED leads with insulating tape.
• The heat sink becomes very hot after use. Be careful not to touch it when removing this receiver.
Heat sink
Instal1-2_KD-G464_002A_1.indd 2
Instal1-2_KD-G464_002A_1.indd 2
12/22/04 11:35:49 PM
12/22/04 11:35:49 PM
