EN
BATTERY BACKUP
The clock, alarm and preset stations settings can be protected against AC power
failure with the batteries for a short period of time. If no backup batteries are installed
or the power failure is prolonged, you will need to set the clock again.
STANDBY MODE
Place the unit on a flat stable surface and plug the power cord into the mains socket.
The unit is in standby mode and “0:00” will flash on the display.
SETTING THE CLOCK
In standby mode, press and hold
SET
until the display flashes.
• Press repeatedly
HR
to set the hours.
• Press repeatedly
MIN
to set the minutes.
• Press
SET
to confirm.
The hour and minute digits will stop flashing.
NOTE: Press and hold
HR
and
MIN
for fast forward.
RADIO OPERATION
Press
POWER
to turn on the radio.
•
The radio frequency (the default FM frequency or the last frequency you tuned) will
briefly appear on the display and then return to clock time.
NOTE:The default FM radio frequency is 87,5 MHz, AM radio frequency is 522 kHz.
• Press repeatedly
BAND
to select the desired radio band.
• Adjust the volume by repeatedly pressing
VOLUME
/
.
• Repeatedly press
TUNING
/
to tune into the desired station.
• Press and hold
TUNING
/
for auto forward or backward radio station searching.
NOTE: For the best FM reception, extend the FM aerial to its full length. For the best AM reception,
rotate the unit to the position giving best reception.
PRESETTING YOUR FAVOURITE RADIO STATION
Up to 10 FM and 10 AM radio stations can be preset.
• Tune into the station that you wish to preset.
• Press and hold
SET
for about 2 seconds, “P01” will flash on the display.
• Press
SET
again to store the station.
• Repeat previous steps to store desired stations.
To listen to preset radio stations, press
MEM
repeatedly to select the desired radio
station.
