MP-XP7220KR,MP-XP5220KR
(No.G1004)1-3
1.1.3 Removing the top case and LCD panel assembly (See
Figure 1 and Figure 5 ~ Figure 8)
• Prior to performing the following procedure, remove the key-
board assembly.
(1) Insert a single-slotted screwdriver or a flat screwdriver in a
space
b
on the underside of the hinge cover. Then, remove
the hinge cover by pulling the screwdriver in the direction
indicated by the arrow.
And then, remove one more hinge cover at the other side
of the main body.
(2) Remove the four screws
B
attaching the top case.
(3) Remove one screw
C
(short) and one screw
D
(long) at-
taching the shield plate.
(4) Reverse the main body, and remove the four screws
E
on
the bottom of the main body. (See Figure 1)
(5) Disconnect the connector wire from the connector CN2 on
the mother board. Similarly, remove the connector wires
from the connectors CN3, CN5, and CN7.
(6) Remove one latch
c
on the rear side of the main body, and
release the two joints
d
while moving the top case in the
rear direction.
Fig.5
Fig.6
Fig.7
Fig.8
CN3
B
B
C
B
D
B
CN7
CN5
Top case
CN2
Shield plate
Space b
Hinge cover
Hinge cover
Latch c
Joint d
Bottom case
Top case
