(No.MB107)1-11
3.1.4 Removing the CD mechanism board
(See Fig.11 ~ 13)
• Prior to performing the following procedure, remove the front
panel assembly, the main board and the CD mechanism
assembly.
(1) Disconnect connector on the CD mechanism.
(2) Remove the four screws
H
on the CD mechanism
assembly.
(3) Cut off the band setting each wire and disconnect the card
wire from connector on the CD mechanism.
(4) Remove the screw
J
attaching the wire on the CD
mechanism board.
Caution:
The metal washer and nut come off.
(5) Remove the four screws
K
attaching the CD mechanism.
Fig.11
Fig.12
Fig.13
H
H
Switch board
CD mechanism
board
CD mechanism
assembly
Front panel
Connecter
Band
J
Band
Connecter
CD mechanism
assembly
Nut
CD mechanism
board
K
K
CD mechanism
assembly
CD mechanism
Содержание Micro Component System CA-UXH9
