6
INSTALLATION
2. ID2 - ID0 : This sets the SCSI ID No. on the drives.
8. How To Close And Lock The Door Of The JVC CD-ROM or CD/DVD Library
䡵
Always close and lock the door before switching ON the JVC CD-ROM or CD/DVD Library.
1. Close the door and lock the key cylinder.
2. Turn the power switch ON.
䡵
Before you add, remove or replace drives, and/or change the SCSI ID No., turn OFF the power of the host computer.
Remember to turn it ON again after completing the necessary operations.
䡵
Set the SCSI ID No. between 0 - 7 using only an ID No. that is not being used by other SCSI devices.
䡵
For the details on default factory settings, please refer to the section “SCSI ID No. SETTING” of the instructions for the
JVC CD-ROM or CD/DVD Library.
3. Set the slide switch.
䡵
Be sure to set the slide switch to N for use. (The position W is provided for service use only.)
7. How To Refit The Drive Storage Cover
䡵
Always refit the drive storage cover before switching ON the JVC CD-ROM or CD/DVD Library.
1. Fasten the cover with the screws that were removed in the procedure ( 2 -1).
Default factory setting
SCSI ID
No.
Switch
Remarks
ID2
OFF
OFF
OFF
OFF
ON
ON
ON
ON
ID1
OFF
OFF
ON
ON
OFF
OFF
ON
ON
ID0
OFF
ON
OFF
ON
OFF
ON
OFF
ON
0
1
2
3
4
5
6
7
9. Automatic Drive Detection Mode
䡵
Please also refer to the corresponding sections in the CD/DVD Library instructions.
䡵
If using the CD/DVD Library MC-8100U/8200U/8600U, be sure to execute the auto drive detection mode after
installing, adding, exchanging or removing drives, to prevent any malfunction.
1.
While holding the “8” key on the control panel, turn on the power of the Library.
2.
When the LCD display shows “DRIVE DETECTION COMPLETED”, turn off the power of the Library.
3.
Turn the Library on again.
