JVC MC-8100LU, Инструкция по эксплуатации

Страница: 30 / 130

E29
ENGLISH
Error Codes
10-2. Error code list
01 UP/DOWN rotary sensor does not change
02 Left slit sensor does not change
03 Right slit sensor does not change
C U 04 UP/DOWN motor does not function
05 UP/DOWN motor doesn’t work correctly or rotary sensor defective
08 UP/DOWN operation exceeds the predetermined duration
09 Upper or lower limit sensor turn on during UP/DOWN operation
10 Tray lock release not possible
C L 11 Tray lock impossible, or lane change not possible
12 Tray lock does not exist at the initial position during carrier movement
20 Catcher (right
a
left) movement operation exceeds the predetermined duration
21 Catcher (left
a
right) movement operation exceeds the predetermined duration
22 Catcher (right
a
left) convergence operation exceeds the predetermined duration
23 Catcher (left
a
right) convergence operation exceeds the predetermined duration
24 Catcher (right
a
left) tray rotary sensor does not change
25 Catcher (left
a
right) tray rotary sensor does not change
C C 26 Right catcher sensor does not turn on
27 Left catcher sensor does not turn on
28 Catcher motor (right
a
left) does not function
29 Catcher motor (left
a
right) does not function
30 Tray does not exist
31 Magazine insertion incomplete, or sensor defective
41 Destination-unknown tray exists on the carrier
C
D 42 No disc in the tray
43 Flip tray does not exist
80 During the flip raise operation, the expected time required is over
F
81 During the flip descent operation, the expected time required is over
E 50 Mail Slot ejecting is not possible
M L 51 Mail Slot loading is not possible
T 52 Destination-unknown tray exists in the Mail Slot
60 Destination-unknown tray exists in the Drive and the control cable of the Drive is disconnected.
T
61 Tray removal is not possible at the drive position
C 62 Disc clamp of the drive does not function
(D#)
E 63 Drive ejection is not possible
D 64 Failure to remove the disc from the drive
S 65 Spindle motor fails to stop (Ejection inhibited status)
Device Description
Device
part
Error
code
*1: # represents the drive number.
*2: Check the magazine loading condition. (
a
See “9-1. Ejecting/loading the magazines” on page E25.)
*2
*1
These errors indicate that the disc is not being moved normally. As the errors cannot be canceled by turning the power off and
then on again, please contact your dealer or local JVC-authorized service agent in order to restore normal operation.
How to restart
10-3. How to cancel Errors “20”, “21” and “64”
1.
Turn off the Power.
2.
Open the door, remove the side and center panels.
3.
Remove the disc or tray from inside the carrier.
4.
Replace the panels and close the door. Then turn on
the power while holding down the “0” key on the control
panel.
CAUTION
First remove the jammed tray or media, otherwise the media may be damaged during subsequent operations.
MC-8100LU(E)-001B 04.10.29, 2:41 PM 29