JVC LT-19DA1BU, Инструкция по эксплуатации

Страница: 12 / 24

12
EN
OPERATIONS
Watching a TV Programme
To select a channel
Press
[TV/DTV]
to switch digital or analogue mode.
Press
[P
/
P (prog.)]
repeatedly to select your desired
channel.
or
Press
[the Number buttons]
to enter a channel number as
three digits for quicker access.
e.g.) If you want to select the channel 24, press
[0]
first, then press
[2]
and
[4]
within 3 seconds.
Press
[P
/
P (prog.)]
repeatedly to select your desired
channel.
or
Press
[the Number buttons]
to enter a channel number as two
digits for quicker access.
e.g.) If you want to select the channel 24, press
[2]
and
[4]
within
3 seconds.
To adjust the volume
Press
[ +
/
– (vol.)]
to adjust the audio volume.
• You can see the volume bar while adjusting the volume.
Press
[ (mute)]
to turn on or off the sound right away.
• You can recover the original volume by pressing
[ (mute)]
again or
[ +
/
– (vol.)]
.
Sleep Timer
You can set the unit to be turned off automatically after a set time
period.
1) Press
[ (sleep)
/
]
.
• Sleep timer display will appear.
2) Press
[ (sleep)
/
]
repeatedly to change the sleep time
period.
• Each time you press
[ (sleep)
/
]
, the timer increases
by 30 minutes up to 120 minutes.
To cancel the sleep timer
Press
[ (sleep)
/
]
repeatedly until “Sleep Off” will appear.
Switching the Input Mode
You can switch the input mode to digital mode, analogue mode or
external input mode.
Press
[AV]
repeatedly to cycle through the input mode.
You can also change the input mode using
[BLUE]
.
1) Press
[BLUE]
.
• “Select Input” menu will appear.
2) Press
[
K
/
L
]
to select the input mode you want, then press
[OK]
.
DTV ATV
DTV
ATV
20
Volume
Mute
DTV ATV
Sleep 30min.
Note:
If you disconnect the unit from the AC outlet or if a
power failure occurs, the sleep timer will be cancelled.
Note:
• To watch the digital channel, select “DTV”.
• To watch the analogue channel, select “ATV”.
• To use the video or S-VIDEO input jack on the unit,
select “Video”.
• To use the SCART jack on the unit, select “SCART”.
• To use the COMPONENT (Y/Pb/Pr) input jack on
the unit, select “Component”.
• To use the HDMI-IN jack on the unit, select
“HDMI”.
• To use the PC-IN (RGB) jack on the unit, select “PC”.
Sleep Off
DTV ATV
PC HDMI
Component SCART
Video Digital channel Analogue channel
Select Input
1. DTV
2. ATV
3. Video
4. SCART
5. Component
6. HDMI
7. PC