English
3
Before assembling—
• Prepare a Phillips screwdriver.
• Place a large, thick cloth on the floor where you assemble the
speaker stand to protect the floor and the speaker stand.
7
Assembling the speaker stand
• Tighten the screws firmly so that no space is left between
the legs and plates.
1
Fix the top plate.
• Align the projection of the legs to the holes of the top plate
correctly, then attach them with three of the supplied
screws
B
(M6 x 16 mm).
* The side without spacer should face outside.
2
Fix the bottom plate and leg holders.
• Align the projection of the legs to the holes of the bottom
plate correctly, then attach them with three of the supplied
screws
A
(M6 x 30 mm).
3
Finally tighten screws
A
and
B
fully.
• Tighten them firmly and fully so that no space is left between
the legs and plates.
7
Attach the speaker on the stand
1
Locate the speaker properly by aligning both screw holes
of the speaker and the speaker stand.
• Do not install the speaker stand on an uneven surface or in
a place subject to vibration.
• Do not install any overweight equipment (over 10
kg)
on the
speaker stand.
2
Fix the speaker with the supplied screws
C
(M5 x 28 mm).
• Do not overtighten the screws, but firmly enough to prevent
the speakers from being shaky.
Assembly
Installing Speaker
Leg
B
(thin)
Screws
A
(M6 x 30 mm)
Spacer
Bottom plate
Leg
A
(thick)
Spacer
Leg holder
Thick cloth
(not supplied)
Screw
C
(M5 x 28 mm)
Spacer
Screws
B
(M6 x 16 mm)
Top plate
Leg
B
(thin)
Leg
A
(thick)
330
260
632
585
15
30
2
Unit: mm
Design and specifications subject to change without notice.
Mass:
5.3
kg
each
Maximum load:
10
kg
Dimensions:
See the diagram.
Specifications
EN_LS-M1[US]4.p65
04.11.4, 4:57 PM
3