JVC LD-HD1KE, Инструкция по эксплуатации

Страница: 18 / 28

18
Basic Operation Procedures
The factory settings of this unit are as follows.
●
Input terminal selection: Auto (Detects input signals sent to the input terminal automatically.)
●
Output terminal selection: HDMI (Digital) (Outputs as RGB 4:4:4 signals.)
Follow the procedures below to set the output if the screen does not appear when in the default state.
●
It may take a while to display the screen upon input of a HDCP signal.
Set using the remote control or buttons at the front of this unit while monitoring the LCD.
●
Press the [EXIT] button when an erratic operation is performed. Alternatively, press the [MENU] button to exit the menu,
then you will be able to repeat the operation from the beginning.
a
Press the [MENU] button.
●
The menu appears on the LCD.
b
Press the [
J
] button.
c
Press the [ENTER] button.
d
Press the [ENTER] button.
e
Press the [
K
] button to select
A
HDMI
(Digital)
B
.
f
Press the [ENTER] button.
g
Press the [
K
] button.
h
Press the [ENTER] button.
i
Press the [
K
] button a few times to
select
A
1080p-60
B
or
A
1080p-50
B
.
●
Select
A
1080p-60
B
when the input signal is NTSC.
●
Select
A
1080p-50
B
when the input signal is PAL/
SECAM.
j
Press the [ENTER] button to confirm
selection.
k
Press the [MENU] button to end the
setting.
●
The display on the LCD disappears.
(The processor exits the setting mode automatically
and the display disappears when no operation is
performed for about 30 seconds.
Setting the Output
ENTER
MENU EXIT
BORDER CROP
Remote control Buttons on this unit
MAIN MENU
INPUT SELECT
MAIN MENU
OUTPUT SETUP
OUTPUT SETUP
Analog/Digital
Analog/Digital
BNC (Analog)
Analog/Digital
HDMI (Digital)
OUTPUT SETUP
Analog/Digital
OUTPUT SETUP
Format
Format
420p
Format
1080p-60
LD-HD1K.book Page 18 Tuesday, December 27, 2005 2:02 AM