2-6
Fig.2-2-9b
2.2.10
Control plate
(1) Take out the slit washer, disengage the 2 hooks while
lifting the control cam side of the control plate, and re-
move the control plate.
Notes:
• After removing the control plate, be careful not to turn
the main deck assembly upside down. Otherwise, parts
such as the idler lever and clutch unit (take up) may
slip out.
• After removing the control plate, the parts shown in the
following figure can be removed. The numbers [
*
] in-
dicate the removal sequence.
2.2.11
Sub brake assembly (take up), control cam
(1) Disengage the spring (a) of the sub-brake assembly (take
up) and, while pushing the hook in the direction of the
arrow, remove the sub brake assembly (take up) upward.
(2) While pushing the claw in the disengaging direction, re-
move the control cam.
Fig.2-2-11a
2.2.12
Slide plate
(1) Disengage the 7 claws on the back side of the mecha-
nism assembly by following the order from the claw on
one end to that on the opposite end, then remove the
slide plate.
Note:
• After removing the slide plate, it is possible to remove
the main brake assembly (take up) and the change arm
assembly.
Fig.2-2-10a
Fig.2-2-12a
Fig.2-2-12b
Reel disk assembly (take up)
Control plate
Slit washer
Idler lever
Slit disk
(take up)
Clutch unit
(take up)
Hook
Hook
Slit washer
Ider arm assembly
[1]
[4]
[3]
[2]
(a)
(a)
Claw
Control cam
Sub brake assembly
(take up)
Spring
Hook
Claw
Claw
Claw
Remove the claws
in order of arrow.
Belt
< Back side of mechanism assembly >
Change arm
assembly
Main brake assembly
(take up)
Slide plate
