JVC KD-SR82BT, Инструкция по эксплуатации

Страница: 30 / 96

26
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
Symptom Remedy
Bluetooth®
“BT DEVICE NOT
FOUND” The unit failed to search for the registered Bluetooth devices
during [AUTO CNNCT] . Turn on Bluetooth from your device
and connect manually. ( 15)
“NOT SUPPORT” The connected phone does not support Voice Recognition
feature.
“ERROR” Try the operation again. If “ERROR” appears again, check if
the device supports the function you have tried.
“H/W ERROR” Reset the unit and try the operation again. If “H/W ERROR”
appears again, consult your nearest service center.
If you have any troubles, try the following:
1 Check TROUBLESHOOTING
2 Reset the unit ( 3)
3 Contact (USA only)
Call: 1-800-252-5722 ( or ) visit: http://www.jvc.com
Symptom Remedy
Bluetooth®
No Bluetooth device is
detected. • Search from the Bluetooth device again.
• Reset the unit.
( 3)
Pairing cannot be made. • Make sure you have entered the same PIN code to both
the unit and Bluetooth device.
• Delete pairing information from both the unit and the
Bluetooth device, then perform pairing again. ( 11)
Echo or noise occurs. • Adjust the microphone unit’s position. ( 11)
• Check the [ECHO CANCEL] setting. ( 13)
Phone sound quality
is poor. • Reduce the distance between the unit and the Bluetooth
device.
• Move the car to a place where you can get a better signal
reception.
Sound is being
interrupted or skipped
during playback of a
Bluetooth audio player. • Reduce the distance between the unit and the Bluetooth
audio player.
• Turn off, then turn on the unit and try to connect again.
• Other Bluetooth devices might be trying to connect to
the unit.
The connected Bluetooth
audio player cannot be
controlled. • Check whether the connected Bluetooth audio player
supports Audio/Video Remote Control Profile (AVRCP).
(Refer to the instructions of your audio player.)
• Disconnect and connect the Bluetooth player again.
“PAIRING FULL” The number of registered devices has reached its limit.
Retry after deleting an unnecessary device. ( 15,
DELETE PAIR)
“PLEASE WAIT” The unit is preparing to use the Bluetooth function. If the
message does not disappear, turn off and turn on the
unit, then connect the device again.
TROUBLESHOOTING
JS_JVC_KD_SR82BT_K_EN_1.indd 26 JS_JVC_KD_SR82BT_K_EN_1.indd 26 11/1/2016 9:03:55 AM 11/1/2016 9:03:55 AM